Card Inspirations an introduction to rubber stamp embossing

		We help you make beautiful greetings cards
\| Shop \| Free Projects \| Contact Us \|

Home - Techniques - Embossing

An introduction to rubber stamp embossing

Embossed image

Use an ink pad suitable for embossing to ink your stamp.
Stamp your design and while the ink is still wet sprinkle embossing powder over the entire design. Tap off excess on to a sheet of paper, this can then be returned to the jar for reuse.
Heat the design to activate the powder. This is usually done with a heat gun. Keep the gun moving with circular motions so you do not overheat one spot. The design will become raised and shiny. This should take about 30 seconds.

Handy hints

Powder tends to stick to areas where you have touched the card so it is a good idea to wipe the card with an anti-static pad or talcum powder before you start.

If you are embossing a black outline it is better to use black ink and clear powder. This saves the powder marking the non-image areas. However, if you have a solid black area such as a silhouette you will need to use black powder to get the intensity of black.

You can use a tinted inkpad for most colours of embossing powder, such as gold and silver, with very little visual difference to using an inkpad of a colour matching the embossing powder.

Top of page

Shop and mail order address:
Card Inspirations, The Old Dairy, Tewin Hill Farm, Tewin,
Welwyn, Herts AL6 0LL, United Kingdom.

Telephone 01438 717000 10.00am to 4.00pm Mon to Sat.
International telephone: +44 1438 717000. (Time zone GMT)

E-mail contact form.

Card Inspirations Ltd is registered in England number 4688879.
Registered Office as above.
Website © Copyright Card Inspirations 1999 - 2007